Manuale d’uso / di manutenzione del prodotto VSGF28NTE del fabbricante Desa
Vai alla pagina of 32
UNVENTED (VENT-FREE) GAS FIREPLACE OWNER’S OPERATION AND INSTALLATION MANUAL THERMOSTATICALLY-CONTROLLED MODELS VSGF28NTE AND VSGF28PTE WITH SPLIT OAK LOGS ® Shown with optional cabinet mantel, hearth base, and trim accessories. Save this manual for future reference.
www.desatech.com 113135-01A 2 WARNING: Improper installation, adjustment, altera- tion, service, or maintenance can cause injury or prop- erty damage. Refer to this manual for correct installation and operational procedures. For assistance or addi- tional information consult a qualified installer, service agency, or the gas supplier.
www.desatech.com 113135-01A 3 WARNING: Do not use a blower insert, heat exchanger in- sert, or other accessory not ap- proved for use with this fireplace. Due to high temperatures, the appliance should be located out of traffic and away from furni- ture and draperies.
www.desatech.com 113135-01A 4 3. If you smell gas • shut off gas supply • do not try to light any appliance • do not touch any electrical switch; do not use any phone in your building • immediately call your gas supplier from a neighbor ’ s phone.
www.desatech.com 113135-01A 5 UNPACKING CAUTION: Do not remove the data plates attached to the heater base assembly. The data plates contain important war- ranty and safety information. 1. With utility knife, cut the carton all the way around above the staples on the bottom tray .
www.desatech.com 113135-01A 6 AIR FOR COMBUSTION AND VENTILATION WARNING: This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ven- tilation air.
www.desatech.com 113135-01A 7 AIR FOR COMBUSTION AND VENTILATION Continued If additional ventilation to adjoining room is sup- plied with grills or openings, add the volume of these rooms to the total volume of the space. 2. Multiply the space volume by 20 to determine the maximum Btu/Hr the space can support.
www.desatech.com 113135-01A 8 WARNING: Never install the fireplace • in a bedroom or bathroom • in a recreational vehicle • where curtains, furniture, clothing, or other flammable objects are le.
www.desatech.com 113135-01A 9 INSTALLATION Continued IMPORT ANT : V ent-free heaters add moisture to the air . Although this is beneficial, installing fire- place in rooms without enough ventilation air may cause mildew to form from too much moisture.
www.desatech.com 113135-01A 10 INSTALLATION Continued INSTALLATION CLEARANCES WARNING: Maintain the minimum clearances. If you can, provide greater clearances from floor, ceiling, and adjoining wall. Carefully follow the instructions below . This will ensure safe installation.
www.desatech.com 113135-01A 11 INSTALLATION Continued Figure 10 - Installing Cabinet Mantel Cabinet Mantel Figure 11 - Location of Nailing Flanges Nailing Flanges 9. If blower is installed, route blower electrical cord through access holes in either side of fire- place.
www.desatech.com 113135-01A 12 INSTALLATION Continued Figure 15 - Attaching Fireplace to Wall Studs Nailing Flanges Nails or Wood Screws Mantel Clearances for Built-In Installation If placing mantel above built-in fireplace, you must meet minimum clearance between mantel shelf and top of fireplace opening.
www.desatech.com 113135-01A 13 INSTALLATION Continued Installation Items Needed Before installing fireplace, make sure you have the items listed below .
www.desatech.com 113135-01A 14 INSTALLATION Continued CONNECTING FIREPLACE TO GAS SUPPLY Installation Items Needed • 5/16" hex socket wrench or nut-driver • Phillips screwdriver • sealant (resistant to propane/LP gas, not pro- vided) 1. Remove fireplace screen.
www.desatech.com 113135-01A 15 Pressure Testing Fireplace Gas Connections 1. Open equipment shutoff valve (see Figure 21). 2. Open main gas valve located on or near gas meter for natural gas or open propane/LP sup- ply tank valve. 3. Make sure control knob of fireplace is in the OFF position.
www.desatech.com 113135-01A 16 INSTALLATION Continued INSTALLING LOGS WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
www.desatech.com 113135-01A 17 NOTICE: During initial operation of new fireplace, burning logs will give off a paper-burning smell. Orange flame will also be present. Open window to vent smell. Operate fireplace on HI position to burn off odor. This will only last a few hours.
www.desatech.com 113135-01A 18 7. Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release contr ol knob. Note: If pilot goes out, repeat steps 3 through 7. This fireplace has a safety inter - lock system. W ait one (1) minute for sys- tem to reset befor e lighting pilot again.
www.desatech.com 113135-01A 19 INSPECTING BURNERS Check pilot flame pattern and burner flame pat- terns often. PILOT FLAME PATTERN Figure 30 shows a correct pilot flame pattern. Fig- ure 31 shows an incorrect pilot flame pattern. The incorrect pilot flame is not touching the thermo- couple.
www.desatech.com 113135-01A 20 CLEANING AND MAINTENANCE WARNING: Turn off fireplace and let cool before cleaning. CAUTION: You must keep control areas, burners, and cir- culating air passageways of fire- place clean. Inspect these areas of fireplace before each use.
www.desatech.com 113135-01A 21 TROUBLESHOOTING Note: All troubleshooting items are listed in order of operation. WARNING: Turn off heater and let cool before servicing. Only a qualified service person should service and repair heater. CAUTION: Never use a wire, needle, or similar object to clean ODS/pilot.
www.desatech.com 113135-01A 22 TROUBLESHOOTING Continued POSSIBLE CAUSE 1. Control knob not fully pressed in 2. Control knob not pressed in long enough 3.
www.desatech.com 113135-01A 23 TROUBLESHOOTING Continued POSSIBLE CAUSE 1. Turning control knob to HI position when burners are cold 2. Air in gas line 3. Air passageways on fireplace blocked 4 . Dirty or partially clogged burner orifice(s) 1. When heated, vapors from fur- niture polish, wax, carpet cleaners, etc.
www.desatech.com 113135-01A 24 WARNING: If you smell gas • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone.
www.desatech.com 113135-01A 25 SPECIFICATIONS VSGF28NTE VSGF28PTE Btu (Low/High) 20,000/28,000 20,000/28,000 T ype Gas Natural Gas Only Propane/LP Gas Only Ignition Piezo Piezo Manifold Pressure 3.4" W .C. 7.9" W .C. Inlet Gas Pressure (in. of water) Maximum 10.
www.desatech.com 113135-01A 26 ILLUSTRATED PARTS BREAKDOWN LOG BASE ASSEMBLY MODELS VSGF28NTE AND VSGF28PTE 3 1 2 17 5 7 8 7 7 18 6 12 26 11 9 15 10 25 13 4 5 5 5 5 21 24 22 18 23 12 19 14 27 20 28 16.
www.desatech.com 113135-01A 27 KEY PART NUMBER NO. VSGF28NTE VSGF28PTE DESCRIPTION QTY. 1 110881-01 110881-01 Front Log (#1) 1 2 110881-02 110881-02 Middle Log (#2) 1 3 110881-03 110881-03 Rear Log (#.
www.desatech.com 113135-01A 28 ILLUSTRATED PARTS BREAKDOWN FIREPLACE MODELS VSGF28NTE AND VSGF28PTE 1 2 3 4 16 16 6 12 18 10 10 7 13 16 26 24 16 23 25 20 24 24 21 16 16 7 17 14 5 16 16 15 8 9 19 22 11.
www.desatech.com 113135-01A 29 PARTS LIST FIREPLACE MODELS VSGF28NTE AND VSGF28PTE This list contains replaceable parts used in your fireplace. When ordering parts, follow the instructions listed under Replacement Parts on page 25 of this manual. KEY NO.
www.desatech.com 113135-01A 30 ACCESSORIES Purchase these fireplace accessories from your local dealer . If they can not supply these accesso- ries, call DESA Heating Products’ Sales Depart- ment at 1-866-672-6040 for information. Y ou can also write to the address listed on the back page of this manual.
www.desatech.com 113135-01A 31 Hearth Base Trim Mantel Trim ACCESSORIES Continued HARDWOOD HEARTH BASE GC3333F Series- Walnut Finished GC3334U Series - Unfinished GC3335F Series - Oak Finished with Me.
Model Serial No. Date Purchased LIMITED WARRANTY VENT-FREE GAS FIREPLACE DESA Heating Products warrants this product to be free from defects in materials and components for four (4) years and five (5).
Un punto importante, dopo l’acquisto del dispositivo (o anche prima di acquisto) è quello di leggere il manuale. Dobbiamo farlo per diversi motivi semplici:
Se non hai ancora comprato il Desa VSGF28NTE è un buon momento per familiarizzare con i dati di base del prodotto. Prime consultare le pagine iniziali del manuale d’uso, che si trova al di sopra. Dovresti trovare lì i dati tecnici più importanti del Desa VSGF28NTE - in questo modo è possibile verificare se l’apparecchio soddisfa le tue esigenze. Esplorando le pagine segenti del manuali d’uso Desa VSGF28NTE imparerai tutte le caratteristiche del prodotto e le informazioni sul suo funzionamento. Le informazioni sul Desa VSGF28NTE ti aiuteranno sicuramente a prendere una decisione relativa all’acquisto.
In una situazione in cui hai già il Desa VSGF28NTE, ma non hai ancora letto il manuale d’uso, dovresti farlo per le ragioni sopra descritte. Saprai quindi se hai correttamente usato le funzioni disponibili, e se hai commesso errori che possono ridurre la durata di vita del Desa VSGF28NTE.
Tuttavia, uno dei ruoli più importanti per l’utente svolti dal manuale d’uso è quello di aiutare a risolvere i problemi con il Desa VSGF28NTE. Quasi sempre, ci troverai Troubleshooting, cioè i guasti più frequenti e malfunzionamenti del dispositivo Desa VSGF28NTE insieme con le istruzioni su come risolverli. Anche se non si riesci a risolvere il problema, il manuale d’uso ti mostrerà il percorso di ulteriori procedimenti – il contatto con il centro servizio clienti o il servizio più vicino.
